Published at Tuesday, May 21st, 2019 - 08:32:50 AM. Hardwood Flooring. By Hilaire Marc.
”Solid” hardwood flooring is traditionally cut from a log in an unfinished plank form with tongue and groove milled on all sides. Ranging from 5/16” to ¾” in thickness, ”solid” floors are typically available in various widths and lengths. Due to the sensitivity of natural ”solid” hardwood from humidity and moisture, natural solid wood floors are normally installed at or above ground level. The natural beauty of wood grains found in solid hardwoods is both appealing and alluring with finishes that may be completed upon installation in the home or factory finished with a pre-determined choice of unlimited finishes to select from. ”Solid” hardwood flooring is as one may expect the most expensive of all wood floor selections. It is not uncommon for ”solid” hardwood floors to exceed two to three times the cost over other floor selections and in most cases is out of reach of those on restricted budget guidelines. Available in a variety of North American wood species, ”solid” hardwood floors are noted for durability and overall beauty that will last a lifetime.
As mentioned earlier, installing hardwood floors is a significant investment which therefore requires proper maintenance to protect your investment and enjoy it for as long as possible. With that in mind, below are some helpful tips on hardwood flooring: Make sure you know your specific type of flooring and finish. You should also be sure to follow the specific manufacturer's instructions for cleaning and general maintenance. Do some research on how to care for your particular kind of finish. For example, paste wax should never be used on polyurethane finish. Sweeping hardwood floors with a soft broom on a regular basis naturally buffs the surface, therefore protecting it from scratches. Another obvious advantage of this is that it will keep the floor clean. Where possible, leave shoes at the door to avoid dragging extra dirt and grime onto the floor. If not, consider using rugs in high traffic areas such as hallways and entrances to keep feet clean. Remove any solid materials from the floor such as sand, grit and dirt among others. These materials are abrasive and can dull and even scratch the floor's finish. Use a dry towel to wipe spills and other messes from wood floors. Oils soaps should NEVER be used on hardwood floors. These oils will eventually build up and will dull the surface of the floor. In addition to this, it will make it difficult to refinish the floor whenever needed. Use a vacuum with a bare floor attachment. Such a vacuum easily removes dirt and dust without scratching or otherwise damaging the floor. Do not drag furniture across the floor when moving it. Instead, lift the furniture when moving it. Where dragging is inevitable, invest in a set of slip-mats. Where these are not available, lids from plastic food containers work just as well. Use only cleaners that have specifically been manufactured for use on hardwood floors. Do not substitute with linoleum, laminate or tile cleaners as these can cause the floor to become extra slippery. Use as little water as possible when cleaning wood floors. Wet spots should also be immediately wiped up after cleaning.
Any content, trademark’s, or other material that might be found on the Familyhealthcareus website that is not Familyhealthcareus’s property remains the copyright of its respective owner/s. In no way does Familyhealthcareus claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.