Published at Thursday, May 23rd, 2019 - 23:08:03 PM. Ceramic Tile. By Lavern Martineau.
If the floor you're covering with ceramic tile flooring is other than concrete, you'll either have to lay concrete first or lay concrete backing boards. The floor in which you'll install your ceramic tile flooring must be as even as possible. If it's not, you'll have to even it out first. Repair all holes and cracks in the floor and clean it thoroughly prior to beginning work. Once the floor is prepared and dried, you can start laying your ceramic tile flooring. It is best to lay the tile in pre-separated sections. Divide the floor into four sections. You can use grout as a line separator. Then, for each section, use a notched trowel to spread the mortar. Hold the trowel at a 45 degree angle so that it creates notches in the spread. This enables better holding when you set in the tile.
For ceramic walls in dry areas not subject to much physical contact most any type of tile and glaze is adequate. For wet areas flat tiles, low relief tiles or even high relief tiles can be used so long as they are not in a hazardous place that a body can inadvertently come into contact with them. A large frog leaping out from your shower wall at body height is probably not a good idea. Obviously, porous tiles are not good for wet areas. So long as the tile is vitreous – has been fired to maturity such that the crystalline structure is unified – the tile or glaze is OK, however the joints between the tiles will need to be sealed. Again, the best bet here is a high fired stoneware tile with a dependable glaze.
Any content, trademark’s, or other material that might be found on the Familyhealthcareus website that is not Familyhealthcareus’s property remains the copyright of its respective owner/s. In no way does Familyhealthcareus claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.