Published at Thursday, May 23rd, 2019 - 15:38:14 PM. Hardwood Flooring. By Maurina Guiraud.
What does the supplier recommend for acclimation? I know you must have heard someone say ”the flooring must sit in your home for two weeks prior to installation”. This is a very general statement and in most cases will do more harm than good for your hardwood floor. If you did this in a new home and it sat in the home while they were drywalling, painting, the wood would be so damp by the time you installed it that you would just be asking for trouble. The fact is a new home will have 1000 to 2000 gallons of water that will be oozing out of the home the first two years. If your flooring is sitting in the home before it is installed it will absorb all of that moisture. If you are having the flooring sit in your home you will want to make sure it is stored in normal living conditions to avoid it from drying out too much or picking up too much moisture. In some cases, a seasonal dwelling, you may want to have the hardwood flooring absorb the moisture before it is installed. If the home is always a high humidity environment then you want the wood to pick up moisture so it can be normal living conditions for that particular environment. You want to have a hygrometer to measure the humidity in your home before the installation and monitor your humidity after to ensure your home is in the proper humidity range to avoid issues with your flooring.
What is the waste factor of the flooring? The waste factor of the flooring is an important issue as well. If 10-15% waste is what is suggested by the manufacturer than that means you will have to buy that much more to get enough to install your entire floor. The higher the recommended waste factor the lower quality the product. You may find when comparing products for price on may be more than the other but you must factor in the difference in waste to the price. A floor for $6 with 3% waste would cost you $6.18 which would be the same cost as a floor with 10% waste that is $5.62 and the product with 3% waste would definitely be a higher quality product. The bottom line is you shouldn't have to sort the waste out of the boxes; the manufacturers should be taking the waste out at the plant so you are only getting good quality pieces you can install in your floor.
Any content, trademark’s, or other material that might be found on the Familyhealthcareus website that is not Familyhealthcareus’s property remains the copyright of its respective owner/s. In no way does Familyhealthcareus claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.